Search results for "irradiation [electron]"
showing 10 items of 34 documents
Effects of high pressure thermal treatments in oxygen and helium atmospheres on amorphous silicon dioxide and its radiation hardness
2009
The effects of thermal treatments at similar to 400 degrees C in oxygen or helium atmospheres at similar to 180 baron the radiation hardness of amorphous SiO(2) are studied. The generation efficiency of several point defects under gamma irradiation is compared to that of the untreated material. All the effects on point defects generation here observed can be explained in terms of changes in the precursor sites. In particular it has been observed that the thermal treatments can change the precursors sites of point defects both through temperature and pressure related processes, not depending on the atmosphere, and through oxygen related processes creating oxygen excess sites. The presence of…
In-situ observation of beta-ray induced UV optical absorption in a-SiO2: radiation darkening and room temperature recovery
2006
International audience; We studied the optical absorption in the 3.0-6.2 eV range induced in bulk amorphous SiO2 by beta-ray irradiation up to similar to 1 MGy at room temperature. The induced absorption was measured in situ both during irradiation and in the post irradiation time. Our data evidence E', center as the main defect induced by irradiation and the partial decay of their absorption band at about 5.8 eV after irradiation. A quantitative analysis of the time evolution of the induced absorption shows that the transmission recovery observed after irradiation is compatible with the reaction of radiation-induced defects with H-related (H-2, H2O) species diffusing in the amorphous matrix
Focused microwave-assisted Soxhlet extraction: An expeditive approach for the isolation of lipids from sausage products
2003
A prototype of extractor based on the conventional Soxhlet principles but assisted in the cartridge zone by focused microwaves is proposed for accelerating the extraction of lipids from sausage products. The extraction process has been optimised using a multivariate design involving the main variables influencing the performance of the prototype (namely, irradiation power P, irradiation time T and number of cycles C). Under the optimum working conditions (P=160 W, T=10 s and C=14), the extraction of lipids from different Spanish sausage products is complete in 45 min. The extracts thus obtained have been compared with those provided by conventional Soxhlet extraction for 8 h by development …
Evaluation of extraction alternatives for Fourier transform infrared spectrometric determination of oil and greases in water
1997
Abstract Liquid-liquid extraction (LLE), solid phase extraction (SPE) and microwave-assisted extraction are evaluated for Fourier transform infrared (FTIR) spectrometric determination of oil and grease in polluted waters. A fast microwave-assisted quantitative procedure is proposed for the total extraction of oil and grease into CCl 4 from water samples, with an irradiation time of 1 min at an exit power of 520 W using closed PTFE vessels. The FTIR quantification of oil and grease is carried out by the measurement of the area under the absorbance spectra in the range between 3058 and 2780 cm −1 , with a baseline established between 3200 and 2700 cm −1 . The analytical features of the propos…
Radiation Response of Ce-Doped Phosphosilicate Optical Fibers
2014
International audience; We report an experimental study of the radiation effects on silica-based multimode optical fibers (OFs) either doped with Phosphorus or with Phosphorus and Cerium. Online Radiation-Induced-Absorption (RIA) measurements were performed in the UV-visible spectral domain under 10 keV X-ray Irradiation. Optical Absorption (OA) in the Near Infrared Region (NIR) and Electron Paramagnetic Resonance (EPR) measurements were also performed on γ-irradiated OFs.
Photovoltaic plant array reconfiguration: Design of a new device
2014
An efficient strategy to improve unequally irradiated PV plants performances is based on the reconfiguration of the connections between the modules. In this paper, an algorithm, for this purpose conceived, is presented. Moreover, the design, realization and finally also the set up of a new reconfiguration system device is fully shown and discussed. The algorithm conceived simulates several possible series-parallel connections under varying irradiation conditions, and determines the optimal modules connection in order to get the maximum output power. In this way, the reconfiguration system may set up the reconfiguration strategy. The reconfiguration system prototype set up, basically consist…
Proposal for SPS beam time for the baby MIND and TASD neutrino detector prototypes
2014
The design, construction and testing of neutrino detector prototypes at CERN are ongoing activities. This document reports on the design of solid state baby MIND and TASD detector prototypes and outlines requirements for a test beam at CERN to test these, tentatively planned on the H8 beamline in the North Area, which is equipped with a large aperture magnet. It is hoped that this will allow for the current proposal to be considered in light of the recently approved projects related to neutrino activities with the SPS in the North Area in the medium term 2015-2020. The design, construction and testing of neutrino detector prototypes at CERN are ongoing activities. This document reports on t…
Depth profiles of aggregate centers and nanodefects in LiF crystals irradiated with 34 MeV 84Kr, 56 MeV 40Ar and 12 MeV 12C ions
2018
I. Manika, J. Maniks and R. Zabels acknowledge the national project IMIS2. A. Dauletbekova, A. Akilbekov, M. Zdorovets and A. Seitbayev acknowledge the GF AP05134257of Ministry of Education and Science the Republic of Kazakhstan.
The role of impurities in the irradiation induced densification of amorphous SiO(2).
2011
In a recent work (Buscarino et al 2009 Phys. Rev. B 80 094202), by studying the properties of the (29)Si hyperfine structure of the E'(γ) point defect, we have proposed a model able to describe quantitatively the densification process taking place upon electron irradiation in amorphous SiO(2) (a-SiO(2)). In particular, we have shown that it proceeds heterogeneously, through the nucleation of confined densified regions statistically dispersed into the whole volume of the material. In the present experimental investigation, by using a similar approach on a wider set of materials, we explore how this process is influenced by impurities, such as OH and Cl, typically involved in relevant concent…
Photooxidation and photostabilization of EVA and cross-linked EVA
2016
Abstract Cross-linked EVA copolymers are widely used as encapsulant material for photovoltaic modules in order to protect the solar cell from the dangerous and degrading environmental factors like moisture and UV radiations. The protection of these modules from photooxidation is the main important objective in their production. In this work, samples of cured EVA in presence of different types of stabilizers have been photooxidized to better understand the photooxidation behavior and the effects of these stabilizers on the mechanical properties. All the results obtained on the cross-linked samples have been compared with those obtained in the same conditions and with the same formulations wi…